hypet systems. |
Send Mail To Us:sales@capmold.com |
|
||||||||||
Cap Mold | Pet Preform Mold | Thin Wall Mold | Blowing Mold | Hot Runner System | |||||||
|
|||
HyPET uses a new part cooling and handling
system called CoolPik, which features: Cooling on the inner surface of the preform without using compressed air, unlike most post-mold cooling systems which only cool the outer surface Optimized cycle utilization — being mounted on the moving platen, the cooling system remains active for up to 85% of the overall cycle HyPET systems are available from 90 to 650 tonnes (900 to 6 500 kN) and up to 216 cavities. HyPET systems offer: Faster cycles Reduced energy consumption Smaller footprint Improved repeatability Rapid set-up |
|||
Huangyan Yichuan Mold Factory
Copyright 2008-2020 www.capmold.com
All Rights Reserved. Design By:ChuangShi
|
||||||||